On-line Installation Manual

Note: Do not attach any fittings to the outlet that will interrupt or stop the water flow through the unit.
This could damage the unit and negate the warranty.

(Image not to scale)

ELECTRICAL

Screw a section of suitable formed conduit (H) with a coupling (G) onto terminal cover (F).  Loosen screw (E) and detach terminal cover and pass the electrical cable through (H) and then connect to terminals marked:


E - Earth (green & yellow)
L - Live (brown)
N - Neutral (blue)


Screw terminal cover (F) back onto unit and secure conduit (H) to wall using a wall bracket (I).


ENSURE ALL ELECTRICAL PIPE JOINTS ARE WATERTIGHT!

PLUMBING
N.B. Plumbing to precede wiring

Screw a ½ inch coupler (B) onto SPEEDHEAT water inlet and tighten the nut (C) to coupler.

[Image of complete shower unit]
At a temperature of 80 degrees celcius the automatic Safety Thermal Cut-Out Switch will activate and the water will go cold. The automatic Thermal Cut-Out Switch will reset itself after about ten secnds with the water flowing.

Click here to print the booklet